This also works on PC power supply header connectors. The Micro-Fit Connector family can withstand operating temperatures up to 125C, is available in multiple circuit sizes and cable lengths for power. Individual staples work too, but can be hard on your thump to push in. ![]() Slip the long ends inside the connector body to push the locking tabs in and release the connector pin. Cut off one "leg" to make it into an "L" shaped piece. However, today Molex makes so many different connectors that there no longer. Open your plain old every day stapler and break off a five or six stables from the "bar" of staples.Ĭarefully break off a pair off individual staples- leave them "glued" together side by side. Unless you are very lucky there won't be any shim material lying on your bench either. ![]() Cable assemblies use only 1 twisted-pair with a gauge as small as 26 AWG and 22 AWG. I'm sure there is a special tool, but it's always days out and you need to fix it NOW! Don't bother trying an extra-tiny screwdriver. 093' Connectors Super Sabre Connectors Ultra-Fit Connectors VersaBlade Connectors. Life is not a contest to see who dies with the most perfect corpse. There is a tab on each side (two of them) that need to be pushed in to release the pin and remove it from the body for repair/replacement. install the shrink wrap first, solder the wires, then slide the wrap to cover the solder, shrink the wrap with a flame, careful the wrap can shrink too much, and split open, then you will need to start over. ![]() Small to tiny Molex connector pins (like on Motorola external speakers) are a pain to remove.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |